Jumpguard DIY Aquarium Cover (47.25 x 29.5 inches) – D-D The Aquarium Solution

Protect your fish from early demise with the Jumpguard Aquarium Cover

• Designed to be cut to size for a custom fit
• Lightweight and easy-to-assemblle
• Maintains high light penetration with no shadowing
• Prevents fish loss due to jumping
• Scratch-resistant extruded aluminum 
• No mounting clips or brackets required
• Tight fit with no gaps

 

The Jumpguard Aquarium Cover Kit supplies everything you need to create a DIY mesh lid to custom fit your tank. Now with black mesh to minimize bounce back, these screen lids have been tested to show only an approximate 2.5% reduction in light penetration, and with zero shadowing! Its scratch-resistant extruded aluminum frame features a lip that sits directly on the edge of your aqurium glass, eliminating the need for additional clips or mounting brackets. The frame also features special corners that provide a tight fit to the glass with no gaps, without interfering with the silicone seams of your aqurium. These specially designed corners also make it easier to cut off the corners for wire management for pumps and heaters.

 

Available in Three Sizes

29.5″ 29.5″ (75cm x 75cm) 

47.25″ x 29.5″ (120cm x 75cm)

70.8″ x 35.4″ (180cm x 90cm)

 

Sizing Notes

1. The maximum size frame that can be made from each kit will be 3.6cm (1.4 inches) longer than stated in each direction.
2. The tank should be measured from inside face of glass to inside face of glass and not the outer dimensions of the tank, which will vary due to glass thickness.

 

Several Jumpguard accesory sets exist to get an even more customized fit for your aquarium:

Multi-Cutout

Flex-Cutout

Brace Bar Set

 

What’s Included?

1x 55″ x 36″ Roll Black Mesh

3x 29.5″ Length Black Extrusion Profile

2x 47.5″ Length Black Extrusion Profile

1x Red Spline Rolling Tool

6x Black Standard Corners

1x 14.4ft Black Spline

2x Black Finger Pull

2x Reverse Corner

2x 29.5″ Brace Bar

6x Brace Clips

2x T Corners